For universal shafts, like universal couplings, they are both important and main products in the website, so the learning requirements and goals are the same, and they are all studied and understood comprehensively and meticulously.
1. If the universal joint shaft is not selected correctly or the quality is unqualified, what problems are likely to occur during use?
If the cardan shaft is not selected correctly or the quality is unqualified, then we are prone to breakage and other problems during its use, or some other problems, which will affect the normal use of the cardan shaft. , causing economic losses to users.
2. What should be paid attention to during the installation of the cardan shaft of the telescopic spline pair?
For the cardan shaft of the telescopic spline pair in the cardan shaft, during the installation process, it is mainly to check the position of the spline sleeve and the spline shaft, whether the two cooperate with each other and whether the degree of cooperation is good. Because if they do not fit well, the universal joint shaft will have an impact during the movement, and then cause its damage.
3. What are the specific lubrication requirements on the cardan shaft? Also, should the cardan shaft be checked daily?
For the lubrication of the cardan shaft, it must be carried out in strict accordance with the specified requirements. For the lubricated parts, ensure that the lubrication is in place and sufficient, so that it has a good lubrication state. For the latter question, the answer is yes, because only by checking its working conditions every day can we ensure the normal use of the universal joint, so as to have a good use effect.
4. What is the balance of the universal joint shaft generally achieved?
The balance of the cardan shaft is generally carried out and realized by balancing the solder lugs. Therefore, based on this, we should pay enough attention to the balance check of the cardan shaft, and take it seriously and carry it out. In addition, when carrying out maintenance work, pay attention to the relationship between the original assembly and whether there is any abnormality.